The DMR BrandMeister Repeater operated by NARC is VE6EMS.
This repeater is using the Yaesu DR-1X Fusion Repeater.
The TX output is 22.3W.
The frequency is 442.2500 MHz (+5 MHz).
The repeater is controlled by a Raspberry Pi Version 3B computer, interfaced to the repeater using a MMDVM-ZUM board mounted on an Arduino DUE single board computer. The Raspberry Pi is linked to the Arduino DUE with a USB cable. The Raspberry Pi runs the repeater control software called MMDVMHost.
Repeater configuration as of Feb. 2, 2017:
Repeater ID: 302602
Repeater Callsign: VE6EMS
Repeater City: Edmonton
Repeater State: Alberta
Repeater Country: Canada
Repeater Frequency: 442.25000
Repeater ColorCode: 1
Repeater Offset: +5.000
Repeater M/P: None
Repeater Time Slots: TS1 TS2
Repeater Trustee: VA6RC
Repeater Network: Brandmeister
The current status of the repeater can be seen at: https://brandmeister.network/?page=repeater&id=302602
Currently we have the VE6EMS repeater set up similar to the VE3YYZ repeater in Toronto, and you can check that site out at: http://www.va3xpr.net/ve3yyz/
The set up of the Channels for the repeater can be found at: http://www.va3xpr.net/brandmeister-talkgroups-reflectors/
Use of Reflectors is the same as described at this site. At the bottom of the page, there is a description on how to bring up the reflectors and it has been verified to work on VE6EMS.
The Static (Permanent) Talk Groups on Time Slot 1 can be changed as required by the Repeater Admin.
The Dynamic (On-Demand) Talk Groups can be used at any time by selecting the channel on your radio corresponding to the Talk Group you want to use and then do a Quick Key of the PTT, which makes the repeater connect to the Talk Group. You then listen for 2 minutes to make sure you are not transmitting over an existing conversation. You will only hear a conversation after the repeater synchs with the network after the connection is completed.